¤ milky moon ¤

I have a 2001 Toyota Camry 4cyl and recently ck eng light came on. The obdII code was p1135 which indicated a/f sensor(O2) bank 1/sensor 1. Disc sensor and took ohm reading,result was O. I replaced O2 with new one, ohm reading was 0.4. Hooked sensor back up, cleared code and shut light.When I started the engine light was out but after a minute it came back on.Rechecked O2 with same results and then checked female connector end with key on and eng off, slots where black leads go read 8 volts one side and 50+ on the other.
Information

Tha sounds absolutely fantastic, Eddie.

I don't like clicking on links, however, so I would be most grateful if you could provide a whole 'nother pile of detailed technical information for me to pore over, please.

For example, what is the ohm when you replace the O2 with say an O2½ or even an O3, and what about if you put the key off and use a male connector instead of a female one (or is that a bit personal?)

Keep it coming, Ed - I love this stuff to very small pieces.

PS - Small point of interest ... Is it a car or a camera?

A spammer that didn't post a link. Fascinating.

I may have snuck in and removed the link

Fascinating.

I love our spammers, more entertaining than your average spammer.

I think there were links when I replied ... so Weirdelves' "may have" may be too modest